The common method of wall stone installation is wet sticking. In recent years, there is a dry hanging method. In fact, in addition to these two more common methods, there is also a direct sticking method.
The dry hanging process:
Secure it to the wall with bolts first. Then make a groove on a piece of stone, fix the stone with a T-shaped frame, and then fix the T-shaped frame and bolts together. Such a marble wall has a certain distance from the wall itself, but the fixation is good.
The wet paste process:
Wet sticking is the most traditional construction method and is generally recognized by construction units. This construction method is to first lay a layer of steel mesh on the wall, and then paste it with concrete slurry.
The direct paste process:
Generally divided into point paste and surface paste. The surface sticking method is suitable for thin stone, the thickness is less than 8MM, and the weight is similar to that of wall tiles. It can be pasted with special mortar. The point paste is to use special glue for stone, the range of the point should not be larger than 25CM, the amount of the point should not be less than 3-4CM, and the thickness of the glue should be above 0.5CM. This method is used for slightly thicker stones.
The direct paste method is not suitable for bathrooms, because the bathrooms are mostly light-weight walls, which have a large degree of deformation, and the bathroom is often wet. Over time, the glue is easy to age, and accidents are prone to occur.
Direct paste is also very important to the wall requirements. First of all, if there is putty on the concrete wall, the putty must be shoveled off and directly attached to the concrete wall. In addition, due to the large deformation of the lightweight wall, if the wall is deformed after gluing, the stone will also change, causing hidden dangers.
