Process 1: The joint part between the bathtub and the stone is pressed against the edge of the bathtub.
Process flow: lofting → angle iron base frame welding installation → steel wire mesh installation → cement mortar plastering → stone installation → bathtub installation
Process standard description:
(1) The joint part between the bathtub and the stone is constructed by pressing the stone on the edge of the bathtub. The stone countertop is cut out of the whole stone according to the size of the bathtub.
(2). The stone parts around the bathtub are made of 4*4 galvanized angle steel support frame, and the stone is installed after the steel mesh cement mortar is painted, and the stone inspection door is reserved. The size and direction of the inspection door must meet the maintenance requirements.
Process 2: The joint part between the bathtub and the stone is pressed according to the construction process of the stone bathtub
Process flow: lofting → angle iron base frame welding installation → steel mesh installation → cement mortar plastering → bathtub installation → stone installation → board seam treatment
Process standard description:
(1). The joint part between the bathtub and the stone is constructed according to the method of pressing the bathtub with the stone. The stone countertop is cut out of the whole stone according to the size of the bathtub.
(2). The stone parts around the bathtub are made of 4*4 galvanized angle steel support frame, and the stone is installed after the steel mesh cement mortar is painted, and the stone inspection door is reserved. The size and direction of the inspection door must meet the maintenance requirements.
Process 3: The joint part between the bathtub and the stone is made flat according to the bathtub and the stone.
Process flow: lofting → brick wall masonry → cement mortar plastering → bathtub installation → stone installation → board seam treatment
Process standard description:
(1). The joint between the bathtub and the stone shall be constructed according to the method of making the bathtub and the stone flat, and leave 2mm at the joint between the stone and the bathtub to close the mouth with weathering glue.
(2). Stone maintenance secret door is left on the side, and the specification and direction of the maintenance door must meet the maintenance requirements
(3). When the stone countertop is a whole piece of stone, it must be cut hollow and edging according to the size of the bathtub during processing in the factory, and the actual transportation conditions on site and the protection of finished products during transportation must be considered.
