For the stone joints on the wall, when drawing, the stone joints should not be spliced with close joints as much as possible, because the construction process is easy to collapse and the quality is not easy to control. The form of V-shaped or U-shaped concave joints can be used for stone splicing.
a. The large area of stone leaves a gap, which can effectively avoid the problem of uneven installation and poor appearance caused by non-vertical stone during the construction of the stone on site.
b. The seam on the stone can effectively alleviate the problem of chromatic aberration and collision caused by the stone itself. After the seam is left, the color difference will be moderated and excessive, not as obvious as the close seam.
c. It can effectively avoid the defects caused by bumps and cutting errors caused by various reasons at the corners of the stone. After the seam is used, the small bumps at the corners will not be so obvious, and its existence will be weakened. Of course, if the corners are bumped greatly, the seam treatment method cannot be covered up, and the stone must be replaced or repaired by the manufacturer.
d. If the pattern of the stone itself is not obvious, or it is close to a solid color (such as Spanish beige.), without the seam treatment, the whole space will appear very weak, and the effect will be the same as the effect presented by the coating. Almost, at this time, you can use the technique of leaving seams to make the whole space tough.
